1、工作电压：dmm1为220v，单相，Zui大功率2000w。dmm2为220v,单相，Zui大功率3000w。
2、输出电压：根据具体工作情况dmm1为100v-400v可调。dmm2为2000v。
3、配备到设定电压后自动停充电功能，并且会自动慢放电，配备过压（设定电压）报警指示功能。
4、切勿使用短线圈（<=3m）充磁，否则易击穿可控硅。
5、本机可对钕铁硼、铁氧体、橡胶磁、塑磁等充磁，具有快速高效高能；多层次保护线路特点，如单次可饱和充磁ferrite20-25kg。
6、工作：接好充磁线圈，接头必须紧固，打开总电源开关，电源信号灯亮，按充电按钮，充电指示灯亮，同时直流电压表电压慢慢上升，到设定电压时自动停止充电，充磁指示灯亮，此时可以充磁了。本机允许电压未到设定电压时就充磁（放电）。
|
1、operating volt: dmm1 is 220v, single-phase, max power 2000w. dmm2 is 2000v, single-phase, max power 3000w。
2、 output volt: basis specific going dmm1 can adjust between 100v-400v. dmm2 is 2000v.
3、the e can automatically stop or start to charge when it get to enactment volt, and can automatically tardily discharge. there are also have a function that can give an alarm when exceed enactment volt.
4、don’t use short wire(<=3m) to fill magnet, otherwise easily break away the rectifier.
5、the e adapt to nd-fe-b\\ ferrite magnets\\ rubber magnets\\ plastic magnets. it has rapid\\ efficient and much protecting systems of important parts. for example single once can saturation fill magnet ferrite20-25kg。
6、operation: link with magnetic wire, the linker must be tightly, turn on the chief power supply, the power supply signal lamp will be light. press the charge button, the charge signal lamp will be light, at one time the volt tardily raise in the direct current volt surface. it will automatically stop charging and the magnetic signal lamp be light, then it can start to fill magnet. the e allow to magnet or demagnetize when it doesn’t receive the enactment volt
|
本产品的品牌是达明DAMON，型号是DMM1DMM2，电源电压是220（V），消耗功率是2000W3000W（W），充磁电压是400V2000V（V），产品单价是8500.00
